GATE

In a roll crusher rolls of diameter 1 m each are set in such a manner that minimum clearance between the crushing surfaces

In a roll crusher rolls of diameter 1 m each are set in such a manner that minimum clearance between the crushing surfaces

Q. In a roll crusher, rolls of diameter 1 m each are set in such a manner that minimum clearance between the crushing surfaces is 15 mm. If the angle of nip is 31o, the maximum diameter of the particle (in mm) which can be crushed is Ans: 52 to 54

In a roll crusher rolls of diameter 1 m each are set in such a manner that minimum clearance between the crushing surfaces Read More »

Hydrogenation of benzene is to be carried out using Ni (density = 8910 kg/m3) as catalyst, cast in the form of non-porous hollow cylinders

Hydrogenation of benzene is to be carried out using Ni (density = 8910 kg/m3) as catalyst, cast in the form of non-porous hollow cylinders

Q. Hydrogenation of benzene is to be carried out using Ni (density = 8910 kg/m3) as catalyst, cast in the form of non-porous hollow cylinders, as shown below. The reaction occurs on all the surfaces of the hollow cylinder. During an experiment, one such cylinder is suspended in the reactant stream. If the observed rate

Hydrogenation of benzene is to be carried out using Ni (density = 8910 kg/m3) as catalyst, cast in the form of non-porous hollow cylinders Read More »

A set of standard stainless steel pipes, each of internal diameter 26.65 mm and 6000 mm length, is used to make a plug flow

A set of standard stainless steel pipes, each of internal diameter 26.65 mm and 6000 mm length, is used to make a plug flow

Q. A set of standard stainless steel pipes, each of internal diameter 26.65 mm and 6000 mm length, is used to make a plug flow reactor by joining them in series to carry out degradation of polyethylene. Seven such pipes are required to obtain a conversion of 66% at 450 K. The minimum number of

A set of standard stainless steel pipes, each of internal diameter 26.65 mm and 6000 mm length, is used to make a plug flow Read More »

In a closed piston-cylinder system, methane was observed to obey the following equation of state

In a closed piston-cylinder system, methane was observed to obey the following equation of state

Q. In a closed piston-cylinder system, methane was observed to obey the following equation of state P(V– nb) = nRT where b = 0.029 m3/mol. The temperature and volume are 500 ºC and 5 m3 respectively for 100 moles of methane. At this state of the system, the isobaric rate of change of temperature with

In a closed piston-cylinder system, methane was observed to obey the following equation of state Read More »

Scroll to Top