Q. A six-faced fair dice is rolled five times. The probability (in %) of obtaining “ONE” at least four times is (A) 33.3 (B) 3.33 (C) 0.33 (D) 0.0033 Ans: 0.33

Q. The number of atoms per unit cell and the number of slip systems, respectively, for a face- centered cubic (FCC) crystal are (A) 3, 3 (B) 3, 12 (C) 4, 12 (D) 4, 48 Ans: 4, 12

Q. The time series forecasting method that gives equal weightage to each of the m most recent observations is (A) Moving average method (B) Exponential smoothing with linear trend (C) Triple Exponential smoothing (D) Kalman Filter Ans: Moving ...

Q. Interpolator in a CNC machine A. controls spindle speed B. coordinates axes movements C. operates tool changer D. commands canned cycle Ans: coordinate feed rates of axes

Q. A grinding ratio of 200 implies that the A. grinding wheel wears 200 times the volume of the material removed B. grinding wheel wears 0.005 times the volume of the material removed C. aspect ratio of abrasive particles used in the grinding wheel is 200 D. ratio of volume of abrasive ...

Q. Using the Taylor’s tool life equation with exponent n = 0.5, if the cutting speed is reduced by 50%, the ratio of new tool life to original tool life is (A) 4 (B) 2 (C) 1 (D) 0.5 Ans: 4 Sol:

Q. The type of weld represented by the shaded region in the figure is (A) groove (B) spot (C) fillet (D) plug Ans: fillet

Q. In a linearly hardening plastic material, the true stress beyond initial yielding A. increases linearly with the true strain B. decreases linearly with the true strain C. first increases linearly and then decreases linearly with the true strain D. remains constant Ans: increases ...

Q. Which one of the following statements is correct for a superheated vapour? A. Its pressure is less than the saturation pressure at a given temperature. B. Its temperature is less than the saturation temperature at a given pressure. C. Its volume is less than the volume of the saturated ...

Q. For an Oldham coupling used between two shafts, which among the following statements are correct? Torsional load is transferred along shaft axis. A velocity ratio of 1:2 between shafts is obtained without using gears. Bending load is transferred transverse to shaft axis. Rotation ...