Q. In a faulted reservoir, the principle of superposition for the pressure drop using diffusivity equation is applicable. This is due to (A) high Reynolds number flow in the well. (B) constant permeability. (C) pressure dependent viscosity. (D) linearity of the diffusivity equation. Ans: linearity of the diffusivity equation.
Q. Which one of the following provides a vertical stab for the flow lines and annulus access lines from multiple wells in offshore subsea completion? (A) Moon pool deck (B) Spider beams (C) Telescopic joints (D) Manifold Ans: Manifold
Q. The annual demand of valves per year in a company is 10,000 units. The current order quantity is 400 valves per order. The holding cost is Rs. 24 per valve per year and the ordering cost is Rs. 400 per order. If the current order quantity is changed to Economic Order Quantity, then the
Q. In an orthogonal machining with a single point cutting tool of rake angle 10°, the uncut chip thickness and the chip thickness are 0.125 mm and 0.22 mm, respectively. Using Merchant’s first solution for the condition of minimum cutting force, the coefficient of friction at the chip-tool interface is (round off to two decimal
Q. A through hole is drilled in an aluminum alloy plate of 15 mm thickness with a drill bit of diameter 10 mm, at a feed of 0.25 mm/rev and a spindle speed of 1200 rpm. If the specific energy required for cutting this material is 0.7 N·m/mm3, the power required for drilling is________W (round
Q. The thickness of a sheet is reduced by rolling (without any change in width) using 600 mm diameter rolls. Neglect elastic deflection of the rolls and assume that the coefficient of friction at the roll-workpiece interface is 0.05. The sheet enters the rotating rolls unaided. If the initial sheet thickness is 2 mm, the
Q. A gas tungsten arc welding operation is performed using a current of 250 A and an arc voltage of 20 V at a welding speed of 5 mm/s. Assuming that the arc efficiency is 70%, the net heat input per unit length of the weld will be __________kJ/mm (round off to one decimal place). Ans:
Q. The figure shows a pouring arrangement for casting of a metal block. Frictional losses are negligible. The acceleration due to gravity is 9.81 m/s2. The time (in s, round off to two decimal places) to fill up the mold cavity (of size 40 cm ´ 30 cm ´ 15 cm) is Ans: 28.92
The figure shows a pouring arrangement for casting of a metal block Read More »
Q. An air standard Otto cycle has thermal efficiency of 0.5 and the mean effective pressure of the cycle is 1000 kPa. For air, assume specific heat ratio γ = 1.4 and specific gas constant R = 0.287 kJ/kg·K. If the pressure and temperature at the beginning of the compression stroke are 100 kPa and
Q. An idealized centrifugal pump (blade outer radius of 50 mm) consumes 2 kW power while running at 3000 rpm. The entry of the liquid into the pump is axial and exit from the pump is radial with respect to impeller. If the losses are neglected, then the mass flow rate of the liquid through
