India’s August GST Collection Surges to ₹1.59 Trillion: In August, India witnessed a notable surge in Goods and Services Tax (GST) collection, amounting to ₹1.59 trillion, signifying an 11% increase compared to the same period last year. This substantial development can be ascribed to improved compliance and anti-evasion measures put in place. Daily Current Affairs […]
India’s August GST Collection Surges to ₹1.59 Trillion Read More »
Moody’s Upgrades India’s 2023 GDP Growth Forecast to 6.7%: Moody’s Investor Service, a global rating agency, has upgraded its economic growth prediction for India, presenting a positive outlook for 2023. The agency has increased its forecast for India’s Gross Domestic Product (GDP) growth to 6.7 percent, up from the previous estimate of 5.5 percent. This
Moody’s Upgrades India’s 2023 GDP Growth Forecast to 6.7% Read More »
World Coconut Day 2023: Every year on September 2nd, World Coconut Day is observed. The day is observed to raise awareness about the benefits of this fruit. In India, Tamil Nadu, Karnataka, Kerala, West Bengal and Andhra Pradesh are the main states that grow coconuts. Daily Current Affairs Quiz: September 2023 What is Coconut? Coconuts
World Coconut Day 2023: Date, Benefits, Significance and History Read More »
Q. The state of stress at a point in a component is represented by a Mohr’s circle of radius 100 MPa centered at 200 MPa on the normal stress axis. On a plane passing through the same point, the normal stress is 260 MPa. The magnitude of the shear stress on the same plane at
Q. The figure shows an idealized plane truss. If a horizontal force of 300 N is applied at point A, then the magnitude of the force produced in member CD is_____N. Ans: 0
Q. If x is the mean of data 3, x, 2 and 4, then the mode is Ans: 3 Sol: Given data are 3, x, 2, and 4
If x is the mean of data 3, x, 2 and 4, then the mode is Read More »
Q. The most common limit gage used for inspecting the hole diameter is (A) Snap gage (B) Ring gage (C) Plug gage (D) Master gage Ans: Plug gage Sol: The most common limit gauge used for inspecting the hole diameter is Plug gauge.
The most common limit gage used for inspecting the hole diameter is Read More »
Q. The cold forming process in which a hardened tool is pressed against a workpiece (when there is relative motion between the tool and the workpiece) to produce a roughened surface with a regular pattern is (A) Roll forming (B) Strip rolling (C) Knurling (D) Chamfering Ans: Knurling Sol: It is a process of
The cold forming process in which a hardened tool is pressed against a workpiece Read More »
Q. The fluidity of molten metal of cast alloys (without any addition of fluxes) increases with increase in (A) viscosity (B) surface tension (C) freezing range (D) degree of superheat Ans: degree of superheat
Q. Hardenability of steel is a measure of (A) the ability to harden when it is cold worked (B) the maximum hardness that can be obtained when it is austenitized and then quenched (C) the depth to which required hardening is obtained when it is austenitized and then quenched (D) the ability to retain its
