JOIN ADRE 2.0 Telegram Group

Control System Quiz | Control System Objective Type Questions and Answers

Questions
21 A controller, essentially, is a
A sensor
B clipper
C comparator
D amplifier

Answer: comparator
22 In a control system the output of the controller is given to
A final control element
B amplifier
C comparator
D sensor

Answer: final control element
Advertisement
Article and Schedule Quiz Start Test!

DOWNLOAD CURRENT AFFAIRS PDF FROM APP

23 In an automatic control system which of the following elements is not used ?
A Error detector
B Final control element
C Sensor
D Oscillator

Answer: Oscillator
24 In a stable control system backlash can cause which of the following ?
A Underdamping
B Overdamping
C Poor stability at reduced values of open loop gain
D Low-level oscillations

Answer: Low-level oscillations
25 Due to which of the following reasons excessive bond width in control systems should be avoided ?
A It leads to slow speed of response
B It leads to low relative stability
C Noise is proportional to band width
D None of the above

Answer: Noise is proportional to band width
26 Which of the following statements is correct for a system with gain margin close to unity or a phase margin close to zero ?
A The system is relatively stable
B The system is highly stable
C The system is highly oscillatory
D None of the above

Answer: The system is highly oscillatory
27 Which of the following statements is correct for any closed loop system ?
A All the co-efficients can have zero value
B All the co-efficients are always non-zero
C Only one of the static error co-efficients has a finite non-zero value
D None of the above

Answer: Only one of the static error co-efficients has a finite non-zero value
28 The second derivative input signals modify which of the following ?
A The time constant of the system
B Damping of the system
C The gain of the system
D The time constant and suppress the oscillations

Answer: The time constant and suppress the oscillations
29 The transient response, with feedback system,
A rises slowly
B rises quickly
C decays slowly
D decays quickly

Answer: decays quickly
30 On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend ?
A Frequency
B Loop gain
C Forward gain
D All of the above

Answer: All of the above
31 The band width, in a feedback amplifier.
A remains unaffected
B decreases by the same amount as the gain increase
C increases by the sane saaaajajt as the gain decrease
D decreases by the same amount as the gain decrease

Answer: increases by the sane saaaajajt as the gain decrease
32 Transfer function of a system is used to calculate which of the following ?
A The order of the system
B The time constant
C The output for any given input
D The steady state gain

Answer: The output for any given input
33 Zero initial condition for a system means
A input reference signal is zero
B zero stored energy
C ne initial movement of moving parts
D system is at rest and no energy is stored in any of its components

Answer: system is at rest and no energy is stored in any of its components
34 A control system with excessive noise, is likely to suffer from
A saturation in amplifying stages
B loss of gain
C vibrations
D oscillations

Answer: saturation in amplifying stages
35 Is an open loop control system.
A Ward Leonard control
B Field controlled D.C. motor
C Stroboscope
D Metadyne

Answer: Field controlled D.C. motor
36 The output of a feedback control system must be a function of
A reference and output
B reference and input
C input and feedback signal
D output and feedback signal

Answer: reference and output
37 Regenerative feedback implies feedback with
A oscillations
B step input
C negative sign
D positive sign

Answer: positive sign
38 As a result of introduction of negative feedback which of the following will not decrease ?
A Band width
B Overall gain
C Distortion
D Instability

Answer: Band width
39 A.C. servomotor resembles
A two phase induction motor
B Three phase induction motor
C direct current series motor
D universal motor

Answer: two phase induction motor
40 Increases the steady state accuracy.
A Integrator
B Differentiator
C Phase lead compensator
D Phase lag compensator

Answer: Integrator

ADRE 2.0 FULL LENGTH MOCK TEST

Take Mock Tests

Missiles Mock Test Start Test!
SSC MTS Mock Test Start Test
IBPS CLERK MOCK TEST Start Test
SSC MTS 2022 JULY 26 Shift 1 (ENGLISH) Start Test!
SSC GD Previous Year Paper 2021 Nov 17 Shift - I (Hindi) Start Test!
SSC CGL Tier - 1 PYP 2022 April 21 Shift- 1 (ENGLISH) Start Test!
MPSC PAPER I MOCK TEST 1 (ENGLISH) Start Test!
IB Security Assistant Mock test 1 (english) Start Test!
UP POLICE CONSTABLE MOCK TEST 1 Start Test!
DELHI POLICE CONSTABLE MOCK TEST 1 (HINDI) Start Test!
Advertisement
Assam Direct Recruitment Test Series