JOIN ADRE 2.0 Telegram Group

Electrical Measuring Instruments MCQs | Electrical Measuring Instruments Multiple Choice Questions(MCQs) & Answers

Questions
1 Hysteresis of an instrument means:
A The change in the same reading when input is first increased and then decreased
B The reliability of the instrument
C The repeatability of the insrument
D The inaccuracy due to change in temperature

Answer: The change in the same reading when input is first increased and then decreased
2 In which part of the scale does the pointer indicate more accurately
A In the first third of the cycle
B In the first half of the cycle
C In about middle of the scale
D In the last third of the cycle

Answer: In about middle of the scale
3 A 150 V moving iron voltmeter of accuracy class 1.0 reads 75 V when used in a circuit under a standard conditions. The maximum possible percentage error in the reading is:
A 0.5
B 1.0
C 2.0
D 4.0

Answer: 2.0
4 The moving iron voltmeters are likely:
A To indicate the same value of the ac as on dc
B To indicate higher value of ac than on dc
C To indicate lower value of ac than on dc
D The moving iron instruments should not be used for dc measurment

Answer: To indicate lower value of ac than on dc
5 Hay’s Bridge is suitable for the measurement of:
A Inductances with Q>10
B Inductances with Q<10
C Capacitors with high dissipation factor
D Capacitors with low dissipation factor

Answer: Inductances with Q>10
6 The ballistic galvanometer is usually lightly damped so that:
A It may oscillate
B It may remain stable
C Amplitude of the first swing is large
D Amplitude of the first swing is small

Answer: Amplitude of the first swing is large
7 Magnetic materials can be tested by:
A Self inductance bridge
B Cambell’s mutual inductance bridge
C AC potentiometer
D All the above

Answer: All the above
8 In CRO astigmatism is:
A Source of generating fast electrons
B Media for absorbing secondary emission electrons
C An additional focus control
D Time-delay control in the vertical deflection system

Answer: An additional focus control
9 Moving iron and PMMC instruments can be distinguished from each other by looking at:
A Pointer
B Terminal size
C Scale
D Scale range

Answer: Scale
10 The deflection of hot-wire instrument depends on:
A Instantaneous value of alternating current
B Average value of current
C RMS value of the alternating current
D Voltage

Answer: RMS value of the alternating current
11 The damping torque must operate only when the moving system of the indicating instrument is:
A Actually moving
B Stationary
C Just starting to move
D Near its full deflection

Answer: Actually moving
12 Air friction damping is used in the instruments which is:
A Moving iron
B Moving coil
C Induction
D Hot wire

Answer: Moving iron
13 An instrument that is capable of measuring only dc is:
A Moving coil
B Moving iron
C Thermo couple
D None of the above

Answer: Moving coil
14 A ballistic galvanometer is used to measure:
A Charge
B Current
C Voltage
D Frequency

Answer: Charge
15 For measuring emf of a standard cell we use:
A Galvanometer
B Potentiometer
C Zener reference
D Electro-dynamic voltmeter

Answer: Potentiometer
16 Introduction of dielectric:
A Increases the capacitance
B Reduces the breakdown voltage
C Reduces the mechanical voltage
D Increases the size of the capacitor

Answer: Increases the capacitance
17 Which of the following instruments have least torque/weight ratio:
A Dynamometer type
B PMMC
C Attraction type moving iron
D Repulsion type moving iron

Answer: Dynamometer type
18 The instrument having its deflection depends upon average value is:
A Moving iron
B Hot wire
C Rectifier type
D Induction type

Answer: Rectifier type
19 Which of the following instruments can be used for full scale deflection of 300o:
A PMMC
B Induction type
C Hot wire
D Electrostatic

Answer: Induction type
20 A Ohmmeter is basically:
A A ammeter
B A voltmeter
C A multimeter
D None of the above

Answer: A ammeter

ADRE 2.0 FULL LENGTH MOCK TEST

Take Mock Tests

Missiles Mock Test Start Test!
SSC MTS Mock Test Start Test
IBPS CLERK MOCK TEST Start Test
SSC MTS 2022 JULY 26 Shift 1 (ENGLISH) Start Test!
SSC GD Previous Year Paper 2021 Nov 17 Shift - I (Hindi) Start Test!
SSC CGL Tier - 1 PYP 2022 April 21 Shift- 1 (ENGLISH) Start Test!
MPSC PAPER I MOCK TEST 1 (ENGLISH) Start Test!
IB Security Assistant Mock test 1 (english) Start Test!
UP POLICE CONSTABLE MOCK TEST 1 Start Test!
DELHI POLICE CONSTABLE MOCK TEST 1 (HINDI) Start Test!
Advertisement
Assam Direct Recruitment Test Series