Engineering Drawing General Knowledge Quiz | Engineering Drawing General Knowledge Short Questions & Answers
Questions
42
The following is not included in title block of drawing sheet.
Answer: Size of sheet
ā Make GKSeries Your Preferred Source on Google
Add GKSeries as Preferred Source
43
By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
Answer: Revolved
44
This type of section is not in direct projection from the view containing the cutting plane:
Answer: Removed section
45
Objects that are symmetric can be shown effectively using this type of section:
Answer: Half section
46
To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
Answer: all of the above
47
When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to ________.
Answer: see the entire bounding area to hatch
48
In offset sections, offsets or bends in the cutting plane are all:
Answer: 90 degrees
49
The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Answer: Half
50
Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical view of a threaded hole.
Answer: Center line
51
Which type of variable is the following list: Thinnest, Thin, Medium, Fat, Fattest?
Answer: Ordinal
52
Which type of variable is the following list: Texas, Utah, California, Delaware?
Answer: Nominal
53
Imagine a āLā shaped face extruded into three dimensions. How many faces does it contain?
Answer: eight
54
In a VR system, all of the following statements about immersiveness are true, except:
Answer: the visual sense is the only sense to affect it
55
All of the following are variables involved in the use of image planes, except:
Answer: the size of the object
56
A cutting plane normal to a face of a cube has to be ___________ in order to cut an oblique face.
Answer: rotated about two axes
57
Which of the following is typically represented in a drawing but does not have a true physical counterpart on the object?
Answer: limiting element of a curved surface
58
When you want to make sure that all of the text stays to the right of a given point on the drawing, you wound set its:
Answer: alignment
59
When you want to make the letters of a line of text narrower, you would set its:
Answer: aspect
60
Where do the projection lines converge in a perspective sketch?
Answer: the vanishing point
