JOIN ADRE 2.0 Telegram Group

Microcontrollers and Applications Quiz | Microcontrollers and Applications MCQs and Answers

Questions
81 Which among the below stated statements does not exhibit the characteristic feature of 16-bit microcontroller?
A Large program & data memory spaces
B High speed
C I/O Flexibility
D Limited Control Applications

Answer: Limited Control Applications
82 Which word size is approved to be of greater importance for performing the small computational tasks along with its storage usability feature adopted by ASCII code?
A 4-bit
B 8-bit
C 16-bit
D 32-bit

Answer: 8-bit
Advertisement
Article and Schedule Quiz Start Test!

DOWNLOAD CURRENT AFFAIRS PDF FROM APP

83 Which minimum mode signal is used for demultiplexing the data and address lines with the assistance of an external latch in a microprocessor while accessing memory segment?
A INTA
B DTE
C HOLD
D ALE

Answer: ALE
84 Why do the microprocessors possess very few bit manipulating instructions?
A Because they mostly operate on bits/ word data
B Because they mostly operate on byte/word data
C Both a & b
D None of the above

Answer: Because they mostly operate on byte/word data
85 How does the microcontroller communicate with the external peripherals/memory?
A via I/O ports
B via register arrays
C via memory
D All of the above

Answer: via I/O ports
86 Which functioning element of microcontroller generate and transmit the address of instructions to memory through internal bus?
A Instruction Decoding Unit
B Timing and Control Unit
C Program Counter
D Arithmetic Logic Unit

Answer: Program Counter
87 Which instructions contribute to an effective adoption or utilization of stack memory which usually plays a crucial role in storage of intermediate results?
A ACALL
B RETI
C PUSH & POP
D All of the above

Answer: All of the above
88 What is the status of stack pointer for the execution of PUSH and POP operations?
A It gets post-decremented for PUSH & pre-incremented for POP
B It gets pre-incremented for PUSH & post-decremented for POP
C It gets pre-incremented for PUSH as well as POP
D It gets post-decremented for PUSH as well as POP

Answer: It gets pre-incremented for PUSH & post-decremented for POP
89 Which among the category of program branching instructions allow 16 bit address to be specified & can jump anywhere within 64K block of program memory?
A Long jumps (LJMP)
B Short jumps (SJMP)
C Absolute jumps (AJMP)
D All of the above

Answer: Long jumps (LJMP)
90 What is the possible range of transfer control for 8-bit relative address especially in 2’s complement form with respect to the first byte of preceding instruction?
A -115 to 132 bytes
B -130 to 132 bytes
C -128 to 127 bytes
D -115 to 127 bytes

Answer: -128 to 127 bytes
91 Which among the single operand instructions complement the accumulator without affecting any of the flags?
A CLR
B SETB
C CPL
D All of the above

Answer: CPL
92 Which rotate instruction/s has an ability to modify CY flag by moving the bit-7 & bit-0 respectively to an accumulator?
A RR & RL
B RLC & RRC
C RR & RRC
D RL & RLC

Answer: RLC & RRC
93 Which form of instructions also belong to the category of logical instructions in addition to bitwise logical instructions?
A Single-operand instructions
B Rotate instructions
C Swap instructions
D All of the above

Answer: All of the above
94 What can be the oscillator period for the multiplication operation of A & B in accordance to 16-bit product especially in B:A registers?
A 12
B 24
C 36
D 48

Answer: 48
95 How many bytes are supposed to get occupied while subtracting indirect RAM from an accumulator along with borrow under the execution of SUBB A, @Ri?
A 1
B 2
C 3
D 4

Answer: 1
96 Which flag allow to carry out the signed as well as unsigned addition and subtraction operations?
A CY
B OV
C AC
D F0

Answer: OV
97 What does the instruction XCHD A, @Ri signify during the data transfer in the program execution?
A Exchange of register with an accumulator
B Exchange of direct byte with an accumulator
C Exchange of indirect RAM with an accumulator
D Exchange of low order digit indirect RAM with an accumulator

Answer: Exchange of low order digit indirect RAM with an accumulator
98 Which instruction should be adopted for moving an accumulator to the register from the below mentioned mnemonics?
A MOV A, Rn
B MOV A, @ Ri
C MOV Rn, A
D MOV direct, A

Answer: MOV Rn, A
99 What kind of PSW flags remain unaffected by the data transfer instructions?
A Auxillary Carry Flags
B Overflow Flags
C Parity Flags
D All of the above

Answer: All of the above
100 How many single byte, two-byte and three-byte instructions are supported by MCS-51 from the overall instruction set?
A 55 – single byte, 35 two-byte & 21 three-byte instructions
B 50 – single byte, 30 two-byte & 31 three-byte instructions
C 42 – single byte, 45 two-byte & 24 three-byte instructions
D 45 – single byte, 45 two-byte & 17 three-byte instructions

Answer: 45 – single byte, 45 two-byte & 17 three-byte instructions

ADRE 2.0 FULL LENGTH MOCK TEST

Take Mock Tests

Missiles Mock Test Start Test!
SSC MTS Mock Test Start Test
IBPS CLERK MOCK TEST Start Test
SSC MTS 2022 JULY 26 Shift 1 (ENGLISH) Start Test!
SSC GD Previous Year Paper 2021 Nov 17 Shift - I (Hindi) Start Test!
SSC CGL Tier - 1 PYP 2022 April 21 Shift- 1 (ENGLISH) Start Test!
MPSC PAPER I MOCK TEST 1 (ENGLISH) Start Test!
IB Security Assistant Mock test 1 (english) Start Test!
UP POLICE CONSTABLE MOCK TEST 1 Start Test!
DELHI POLICE CONSTABLE MOCK TEST 1 (HINDI) Start Test!
Advertisement
Assam Direct Recruitment Test Series