theory of structures objective type questions and answers
Questions
Free download in PDF Theory of Structures Objective Type Questions and Answers for competitive exams. These short objective type questions with answers are very important for Board exams as well as competitive exams. These short solved questions or quizzes are provided by Gkseries.
21
Pick up the correct statement from the following:
A
A wire wound in spiral form, is called a helical spring
B
The pitch of a close coil spring, is very small
C
The angle made by the coil with horizontal, is called the angle of helix
23
A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is
24
A simply supported uniform rectangular bar breadth b, depth d and length L carries an isolated load W at its mid-span. The same bar experiences an extension e under same tensile load. The ratio of the maximum deflection to the elongation, is
28
If a solid shaft (diameter 20 cm, length 400 cm, N = 0.8 × 105 N/mm2) when subjected to a twisting moment, produces maximum shear stress of 50 N/mm 2, the angle of twist in radians, is
29
A spring of mean radius 40 mm contains 8 action coils of steel (N = 80000 N/mm2), 4 mm in diameter. The clearance between the coils being 1 mm when unloaded, the minimum compressive load to remove the clearance, is
32
The maximum deflection due to a uniformly distributed load w/unit length over entire span of a cantilever of length l and of flexural rigidly EI, is
35
For determining the force in the member AB of the truss shown in the given figure by method of sections, the section is made to pass through AB, AD and ED and the moments are taken about
39
A close coil helical spring of mean diameter D consists of n coils of diameter d. If it carries an axial load W, the energy stored in the spring, is
40
A compound bar consists of two bars of equal length. Steel bar cross -section is 3500 mm2and that of brass bar is 3000 mm2. These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm2 and Eb = 0.1 MN/mm2, the stresses developed are:
